|
|
|
| Oscillation
Range |
| |
 |
 |
|
| Robo-Pong
540 has no oscillation controls. The oscillation ranges will
apply to the 1040 and 2040 only when these models are positioned
so the robot head is aligned with the centerline of the table.
Models 1040 and 2040 have 8 selectable ranges regulated by the
two Control Levers at the back of the robot. The Right Control
Lever is restricted to positions 1, 2, & 3; the left to
positions 4,5, & 6. To move a lever, lift it up with your
finger, move it to the desired position, and then release it.
If the lever will not move easily,pick up the the lever and
move the Control Levers on the 2040, open the slot in the back
of the net by pulling the velcro apart and reach with your fingers
through the slot to touch the Control Levers. |
| |
| Positions
of the Control Levers L & R |
Oscillation
Range |
| 4、3 |
whole
table
(from corner to corner) |
| 5、3 |
3/4
table (from player's left corner to middle of right court) |
| 4、2 |
3/4
table (from player's right corner to middle of left court) |
| 4、1 |
1/2
table (from player's right corner to centerline) |
| 6、3 |
1/2
table (from player's left corner to centerline) |
| 5、2 |
1/2
table (from middle of player's right court to middle of
left court) |
| 5、1 |
1/4
table (from middle of player's right court to centerline) |
| 6、2 |
1/4
table (from middle of player's left court to centerline) |
| 6、1 |
No
oscillation |
|
|
| If
you want stationary delivery, adjust the Control Levers to 3,
4 and turn oscillator speed on. When the robot head points to
the desired landing spot on the table, turn Oscillator Speed
off. Failure to set the levers to 3, 4 may result in "head
drift", which causes the landing spot to change even though
the oscillator is turned off. |
| WARNINGS:
DO NOT adjust the Control Levers while the head is moving. Also
do not move both levers at the same time. Move one, then the
other. |
|
|
