Home>>Welcome to the Support Page
 
Oscillation Range
   
Robo-Pong 540 has no oscillation controls. The oscillation ranges will apply to the 1040 and 2040 only when these models are positioned so the robot head is aligned with the centerline of the table. Models 1040 and 2040 have 8 selectable ranges regulated by the two Control Levers at the back of the robot. The Right Control Lever is restricted to positions 1, 2, & 3; the left to positions 4,5, & 6. To move a lever, lift it up with your finger, move it to the desired position, and then release it. If the lever will not move easily,pick up the the lever and move the Control Levers on the 2040, open the slot in the back of the net by pulling the velcro apart and reach with your fingers through the slot to touch the Control Levers.
 
Positions of the Control Levers L & R Oscillation Range
4、3 whole table
(from corner to corner)
5、3 3/4 table (from player's left corner to middle of right court)
4、2 3/4 table (from player's right corner to middle of left court)
4、1 1/2 table (from player's right corner to centerline)
6、3 1/2 table (from player's left corner to centerline)
5、2 1/2 table (from middle of player's right court to middle of left court)
5、1 1/4 table (from middle of player's right court to centerline)
6、2 1/4 table (from middle of player's left court to centerline)
6、1 No oscillation
 
If you want stationary delivery, adjust the Control Levers to 3, 4 and turn oscillator speed on. When the robot head points to the desired landing spot on the table, turn Oscillator Speed off. Failure to set the levers to 3, 4 may result in "head drift", which causes the landing spot to change even though the oscillator is turned off.
WARNINGS: DO NOT adjust the Control Levers while the head is moving. Also do not move both levers at the same time. Move one, then the other.

Copyright©2005-2006 Zhuhai Lai De Sports Goods Co.,Ltd. All Rights Reserved